TanToday - Helping Salon Owners, One At A Time, Since 2000! - View Single Post

Brian Oshman · 1st October 2007, 11:48 PM

Does the bed run fine in stand alone mode if it is disconnected from the timer system?

Apparently you have changed the boards I was talking about. See if you have a static problem or loose wiring in the bed. Check the grounds. You could have gotten another defective board too. That is not unlikely.

1st October 2007, 11:48 PM	#4 (permalink)
Brian Oshman Off The Chain Moderator Join Date: Nov 2004 Location: The Sun Doctor, Califon, NJ Posts: 7,266	Re: error message Does the bed run fine in stand alone mode if it is disconnected from the timer system? Apparently you have changed the boards I was talking about. See if you have a static problem or loose wiring in the bed. Check the grounds. You could have gotten another defective board too. That is not unlikely. __________________ Three can keep a secret if two are dead.