TanToday - Helping Salon Owners, One At A Time, Since 2000! - View Single Post - Setting 'max number of beds' in T-Max Manager

Brian Oshman · 13th April 2008, 12:42 PM

Sounds like you have the regular manager with 8 displays. To set the max bed number press and hold down the start/stop buttons under display 1 and 8 until the displays change.

Under display 3 press the set button until the display shows the max number of beds you want then press the change display beds button on the lower left corner of the manager to save the changes.

There are no codes for this version, it uses a key instead if it has a key lock installed. If it has the key then make sure the key is oriented in the horizontal position if the manager case is vertical hanging on a wall. The key edge will point towards the displays. This will allow you to access the parameters.

13th April 2008, 12:42 PM	#11 (permalink)
Brian Oshman Off The Chain Moderator Join Date: Nov 2004 Location: The Sun Doctor, Califon, NJ Posts: 7,041	Re: Setting 'max number of beds' in T-Max Manager Sounds like you have the regular manager with 8 displays. To set the max bed number press and hold down the start/stop buttons under display 1 and 8 until the displays change. Under display 3 press the set button until the display shows the max number of beds you want then press the change display beds button on the lower left corner of the manager to save the changes. There are no codes for this version, it uses a key instead if it has a key lock installed. If it has the key then make sure the key is oriented in the horizontal position if the manager case is vertical hanging on a wall. The key edge will point towards the displays. This will allow you to access the parameters. __________________ Three can keep a secret if two are dead.