TanToday - Helping Salon Owners, One At A Time, Since 2000! - View Single Post

Brian Oshman · 21st June 2008, 12:56 PM

Sounds like the bed is resetting. Don't go by the software. Does the timer reset to zero in the room? Could be a bad lamp in the bed. These beds have a sensor on the board to detect transiesents caused by flickering or shorted lamps and shut the bed down.

Removing Q1 and Q2 off of the board eliminates this but if you are not skilled with working on circuit boards then don't attempt this as you might fuque it up.

21st June 2008, 12:56 PM	#11 (permalink)
Brian Oshman Off The Chain Moderator Join Date: Nov 2004 Location: The Sun Doctor, Califon, NJ Posts: 7,034	Re: Sundash 232 problem Sounds like the bed is resetting. Don't go by the software. Does the timer reset to zero in the room? Could be a bad lamp in the bed. These beds have a sensor on the board to detect transiesents caused by flickering or shorted lamps and shut the bed down. Removing Q1 and Q2 off of the board eliminates this but if you are not skilled with working on circuit boards then don't attempt this as you might fuque it up. __________________ Three can keep a secret if two are dead.