Just got a Magic, lots of questions

[EliteMike]

Patryk told me it should be between 125-130 in the center? is this incorrect?

[BIG AL]

125-130 is good. It is most likely that you will need to set the lamps to level 2 to get that reading. Both of my beds were set on level 2 from the start. Get the mug 6 glass for the bed. It will make a total difference in the bed. The great part about this bed is
you can fine tune the lamps to read what you want them to read.
I have mine set at 130 on top and the high 80's on the bottom and I have never had anyone complain about an uneven tan.

[EliteMike]

Well, I finally got facials working. Still have the hot column though. I'm tempted to try and swap fans on that column with another set.

The problem was either a bad main board or the triac board...

[solarmeter®]

Aren't circuit boards and transformer legs fun?



This bed is not for the simple minded ©. Good thing your mind is complicated!

Glad the facials are OK now. Figure out the "hot" bank and you're good to go.

© Paris, Lindsay, and Brittany.

[EliteMike]

Well I didn't figure out the hot spot, but I did increase the other 2 columns to give a more even feeling. The canopy is metering between 127-130 in the middle.

I made it through 12 mins, it was HOT, but what do you expect. Mug 6 was ordered today.

[EliteMike]

Mug 6 arrived today, although I had to step out so I won't install it until later today or tomorrow morn

[sparky]

you'll get better comfort and performance with only a 10 min session, after MUG6.

[EliteMike]

do you still tan people at 12 mins sparky?