Network Sites: LOOKING FIT National Tanning Training Institute
| Network Sites: LOOKING FIT National Tanning Training Institute |
| |||||||
| Visit Our Sponsors! |
| I NEED HELP Forum Problems with software, timers, build outs, etc. Come and post here. |
 |
| | LinkBack | Thread Tools | Display Modes |
20th June 2008, 11:57 PM
| #1 (permalink) |
| Rookie Join Date: Jul 2005 Location: Wonderful Colorado
Posts: 15
|  Sunscape Buck booster??? I have a 2007 ETS Sunscape I have installed and I need to find out if I really need a 3.0 kva buck booster ( as recomended by ETS). I have it on a 100 amp single phase breaker, and it operates at 85 amps. I have 211 operating volts and want to use a 12/24 booster. Can I use a 2.0 kva and be OK??? |
|  |
| 21st June 2008, 11:36 AM | #2 (permalink) |
| Off The Chain Moderator  Join Date: Nov 2004 Location: The Sun Doctor, Califon, NJ Posts: 6,486 | Re: Sunscape Buck booster??? 2.0 is good to 80 amps. Technically you need a 3.0 but if you already have the 2.0 then hook it up. If it hangs then cool, if it burns up then you will need to buy one anyway. It will probably run without problems since the bed will have short session times. It is not running 100% duty cycle. __________________      Three can keep a secret if two are dead. |
 | |
|
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
