Network Sites: LOOKING FIT National Tanning Training Institute
| Network Sites: LOOKING FIT National Tanning Training Institute |
| |||||||
| Visit Our Sponsors! |
| T Max ADI Forum All you want to know about T Max Timers |
 |
| | LinkBack | Thread Tools | Display Modes |
18th February 2008, 05:58 PM
| #1 (permalink) |
| Super Star  Join Date: Nov 2004 Location: texas
Posts: 601
|  Display problems We have an older manager, I came in the other night and noticed the last 4 "beds" were not as bright as the first "beds" I reset the power and it all went away (all displays were the same brightness) Power pack? Thanks! |
|  |
| 22nd February 2008, 06:34 PM | #2 (permalink) |
| Off The Chain Moderator  Join Date: Nov 2004 Location: The Sun Doctor, Califon, NJ Posts: 6,912 | Re: Display problems More like a loose solder joint on the board. When you unplugged it and plugged it back in, it must have jiggled the board. If it was the power pack it would either not light up or over volt ther unit and it would run hot and lock up. __________________      Three can keep a secret if two are dead.  |
| | |
|
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
