T-Max will not control MT3500

[cosmo26062]

I Have just received my new 3A and communication box from MT. The T-Max has been chained in and the timer addressed. The Manager Pro communicates fine with the new 3A but the T-Max
does not operate the MT. When the MT is set from the desk it sets the 3A and then within a few seconds goes to dirty.

I know there is a software setting to enable the T-Max via Hyperterminal but there is no way I'm getting into that until I get some advice. Perhaps it's a setting in the Master Menu? No documentation came with the timer and the manual is of no help.

At this point I'm wondering if it's worth using the T-Max. This leaves me with only the Spray Counter as inventory/theft control
which could be a problem...

Thanks in advance for any help!!

[Tanning Queen]

T-Max Contact Info

Contact Applied Digital directly and they will walk you thru your issues.

[Brian Oshman]

That is normal. The manager just sends a signal for the level you send then goes to dirty. The T-max does not control the session, it is simply a display. Once the time is sent then the button on the inside of the booth controls the start of the cycle.

11 min, jug 1 level 1. 21 min, jug 2 level 1

12 min, jug 1 level 2. 22 min, jug 2 level 2

13 min, jug 1 level 3. 23 min, jug 2 level 3

Do not sell the booth as levels. Don't even tell the client that there are levels. This is used based on client size and should be set accordingly otherwise you will get an 80 pounder wanting level 3 and they will just be soaked down with too much solution. The solution only makes you so dark, it is not like paint where the more you apply the more you get.