Convert Ergoline Affinity 500 to single phase - TanToday - Helping Salon Owners, One At A Time, Since 2000!

timeout · 21st July 2008, 04:39 PM

Anybody know what wires to cut and cap ? or which ones to move.

Bed is currently setup for three phase. I need to switch it to single .

I am comfrotable working with wiring , just not sure about following the diagram in the bed.

Thanks

Brian Oshman · 21st July 2008, 08:20 PM

L1, L2, L3 become phase 1 and N1, N2, N3 become phase 2.

timeout · 22nd July 2008, 01:24 PM

Brian -

So I should cut the jumpers on the left side (already did).

Then on Input side :

Then I should have one red line going into L1 with jumpers to L2 and L3 .

Then the other line in going to N1 with jumpers to N2 and N3 .

Is that right?

Brian Oshman · 22nd July 2008, 01:32 PM

Yup, tie L1, L2, L3 together and tie N1, N2, N3 together. Try to branch both jumpers off of where you connect the main to so the first jumper is not carrying the load of two terminals.

timeout · 22nd July 2008, 01:41 PM

sweet. Thanks!

21st July 2008, 04:39 PM	#1 (permalink)
timeout All Star Join Date: Aug 2005 Posts: 118	Convert Ergoline Affinity 500 to single phase Anybody know what wires to cut and cap ? or which ones to move. Bed is currently setup for three phase. I need to switch it to single . I am comfrotable working with wiring , just not sure about following the diagram in the bed. Thanks

21st July 2008, 08:20 PM	#2 (permalink)
Brian Oshman Off The Chain Moderator Join Date: Nov 2004 Location: The Sun Doctor, Califon, NJ Posts: 6,077	Re: Convert Ergoline Affinity 500 to single phase L1, L2, L3 become phase 1 and N1, N2, N3 become phase 2. __________________ Three can keep a secret if two are dead.

22nd July 2008, 01:24 PM	#3 (permalink)
timeout All Star Join Date: Aug 2005 Posts: 118	Re: Convert Ergoline Affinity 500 to single phase Brian - So I should cut the jumpers on the left side (already did). Then on Input side : Then I should have one red line going into L1 with jumpers to L2 and L3 . Then the other line in going to N1 with jumpers to N2 and N3 . Is that right?

22nd July 2008, 01:32 PM	#4 (permalink)
Brian Oshman Off The Chain Moderator Join Date: Nov 2004 Location: The Sun Doctor, Califon, NJ Posts: 6,077	Re: Convert Ergoline Affinity 500 to single phase Yup, tie L1, L2, L3 together and tie N1, N2, N3 together. Try to branch both jumpers off of where you connect the main to so the first jumper is not carrying the load of two terminals. __________________ Three can keep a secret if two are dead.

22nd July 2008, 01:41 PM	#5 (permalink)
timeout All Star Join Date: Aug 2005 Posts: 118	Re: Convert Ergoline Affinity 500 to single phase sweet. Thanks!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode